Special Events FF: Antique Tractor Pull

Superintendents: Charlie Cook 615-714-6651

                          Tyrell Jackson 615-578-4143

                          Phillip Benton 615-585-7245
Tuesday, August 26, 2008 7:00PM
Location: Arena

YOU MUST HAVE EXHIBITOR NUMBER TO ENTER

Rules: Robertson County Antique Tractor Association Rules Apply - Not good for member points

Hook Fee - $15.00

Wheelie Bars Enforced

1.   Antique Tractors 1900 - 1959, Open tractors 1900 - 1959
2.   Serial numbers must be intact and not tampered with.

3.   Gas & Diesel.
4.   Tractors must weigh within limits of each weight class (40 lb. tolerance).
5.   Tractors are allowed (3) three hooks.  If tractor is pulled in a Powder Puff Class, it is allowed one (1) additional hook.   

      Tractors in Powder Puff must be "in the family" tractors. 
6.   Factory high R.R.M. only 20% override allowed. Tractors subject to R.R.M. check. All tractors to have positive throttle  

      stops.

7.   Tractors must retain stock engine and stock appearance. Board of directors will have final approval of all tractors.  Cut 

      tires allowed.  16.9 tires allowed on 18" max. width.  18.4 tires allowed in the 6500 lb. Class and up.  Horizontal ring   

      hitch 20" high.  No balls allowed 18" from center of axle to sled hitch.  Hook needs to fit freely in hook point.  No part of 

      drawbar may extend rearward beyond point of hook.  Drawbar must be stationary in all directions!  18.4 tires allowed in 

      all Outlaw and Open classes.

8.   Add on weights allowed. They must not extend more than 11" from the center of the rear axle of the tractor to the   

      furthest point forward and must not extend rearward beyond rear tires.  Weights or objects to fall on track while tractor 

      is hooked to sled will result in tractor being disqualified.  Pull ends when any tire or part of sled touches boundary line.
9.   Pullers under 18 requires track official and parent or guardian approval.  Anyone under 13 years of age has to have walk 

      beside kill switch in any class they are pulling in.
10. All antiques pull in 1st gear not to exceed 3.5 mph and must start with tight chain. Driver must stay in seat of tractor, no 

      bouncing and hands must be on the steering wheel, hand clutch, hand brakes, or throttle at all times during the pull.  Kill 

      switches required in Open and Outlaw Classes.
11. Each puller has two (2) attempts to pass the 40 ft. mark pull is official after 40 ft. mark is
      passed. Pull is over when forward motion of sleds is stopped or red flag is dropped.
12. Front tires may not leave ground more than 18" during pull.  If you don't have Wheelie bars, YOU DO NOT PULL!  

      Wheelie bars are required on all tractors.  They must be installed 10" above ground level.  They must have a 5"x5" skid

      pad and must extend 5" past the furthest point of rear tires.

13. No one on track except pullers and officials during pull.  One (1) adult is allowed on track with child or inexperienced 

      driver.
14. No differentials or drive line alterations.
15. A protest must be filed within weight class before next class begins.  Any tractor found illegal by the official's decision 

     will be disqualified.  Protestor's tractor will be checked first.

16. Anyone can be disqualified for non sportsmanlike conduct, intoxication or failing to stop when red flagged by an official.  

     Anyone operating a tractor in an unsafe manner on or off the track will be disqualified.
17. Regular Classes - (1st gear) 3.5 mph: 20% rpm.  

     Open Classes - 6.0 mph: 20% rpm

     Outlay Classes - Any gear, any rpm

18. For safety purposes, ALL outlaw tractors must have a steel or aluminum side shield in a minimum thickness of .060".  

     ALL Outlaw Tractors must have an Approved Scatterblanket or Scatter Shield made of 1/4 inch steel, be 6" in width 

     secured by 3-3/8 inch grade, 8 bolts per side.  It needs to secure 360 degrees around bell housing, centered over 

     flywheel & clutch.  Inspection of your tractor will be performed by tech officials before weigh in of class.

19. FARM STOCK - FACTORY RPM'S  Must have factory block, factory heads, factory cranks, factory ignition system, factory 

     carb. and fuel system, factory rpm's, fuel 93 octane max fuel.  Must have Wheelie bars, must have stock drawbar

     (max. 18" height, length 18" or longer) with twisted clevis.  Front weight bracket - can be a max. of 5" wide and a max of

     1/2" thickness and must not extend more than 10" from the center of the rear axle to the furthest point forward.  Weights

     can  not be installed further than fron tires.  Must run stock wheel - (pressed steel if they were available from the factory

     for that model)

     FARM STOCK - Classes 4,000 - 4,500 Tire size 13.6 max.

                      Classes 5,000 - 5,500 Tire size 14.9 max.

                      Classes 6,000 - 6,500 Tire size 15.5 max.

                      UNCUT ON ALL FARM STOCK

20. A JUDGE'S DECISION IS ALWAYS FINAL!

TRACTOR CLASSES
4500 - Farm Stock

5500 - Farm Stock

6000 - Farm Stock

6500 - Farm Stock

3500 - Regular

4000 - Regular

4500 - Regular

5000 - Regular

6000 - Regular

6500 - Regular

4000 - Super Farm

4500 - Super Farm

5000 - Super Farm

5500 - Super Farm

6000 - Super Farm

6500 - Super Farm

4250 - Open

5250 - Open

5750 - Open

6250 - Open

4250 - Outlaw

4500 - Outlaw

5000 - Outlaw

5000 - Hot Rod

5500 - Hot Rod

King of Hill - $200 1st Place  5230 lbs - No tolerance, 1st gear, 4 MPH, Cut or Uncut Tires